Sim2 HT3000 Manual de instalación descargar pdf (Pagina 10)

ht3000

5 SWITCHING THE PROJECTOR ON AND OFF

WARNING: Connect the projector to a power supply with a

nominal voltage within the following values: 100-240 V AC,

50/60 Hz. It must be earthed (Fig. 12).

GRAPHICS RGB

S-VIDEO

AUDIO OUT

HDMI 1

REMOTE

S-VIDEO

ESC

INPUT

Power Switch:

Position I: On

Position 0: Off

Fused

Power Socket

Power Plug

Fig. 12

In position I the projector will initialise itself (red and green leds

on) and then goes into standby mode (red led on) (Fig. 13).

ESC

SWITCH ON FROM STANDBY

With the remote control: press one of the keys 1...9 or with 0.

With the keypad: press the ON/OFF button.

)

-V

ESC

When the unit is switched on from standby the lamp switches

on; after a brief period of warming up, the image displays (blue

led on). The projected image comes from the input selected

when the unit was last switched off (Fig. 14).

If a very short time has passed since the unit was last switched

off, the lamp may not switch on beause it is too hot.

Just wait a few minutes for the lamp to cool down sufficiently.

Fig. 13

Fig. 14

Downloaded From projector-manual.com Sim2 Manuals

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

Sin comentarios

Sim2 HT3000 Manual de instalación Pagina 10