Sim2 HT5000 Manual de usuario descargar pdf (Pagina 11)

• 1 bytes (byte 0) that initiates the packet (1E)

• 17 bytes (bytes 1-17) that duplicate the sent command (apart from 2 of them — the CRC)

• 3 Error bytes (bytes 18-20) that signal errors in the processing of the command

• 4 Data bytes (bytes 21-24) that contain the requested data

If the 3 Error bytes (bytes 18-20) are 00 00 00 then requested data are valid.

The tables below explain the meaning of returned data.

• Byte 21 (labeled SS in the table above) contains current Input Status:

OK 00

No Signal 01

Signal Out of Range 02

• Byte 24 (labeled II in the table above) contains Current Input:

1 Video 00

2 S-Video 02

3 YPrPb 04

RGB 05

4 YPrPb 06

RGB 07

5 GRAPHICS 1 RGB 0C

GRAPHICS 1 YPrPb 0D

6 GRAPHICS 2 RGB 0E

GRAPHICS 2 YPrPb 0F

7 DVI RGB 10

DVI YCrCb 11

8 HDMI 1 12

9 HDMI 2 13

10 HDMI 3 14

11 HDMI 4 15

12 HDMI 5 16

13 HDMI 6 17

14 SDI 18

If the unit is in Standby State the unit does not respond to this command.

Lamp Status

When then unit is On, the returned packet (27 byte long) is described in the following table:

1E BE EF 10 13 00 .. .. 01 01 00 01 01 15 01 00 01 10 00 00 00 UU UU .. SS LL LL

0 1 17 18 20 21 22 24 25 26

where bytes marked with .. are not relevant.

The response may be separated into 4 parts:

• 1 bytes (byte 0) that initiates the packet (1E)

1 2 ... 6 7 8 9 10 11 12 13 14

Sin comentarios

Sim2 HT5000 Manual de usuario Pagina 11