Sim2 HT 280E Manual de instalación descargar pdf (Pagina 11)

5 SWITCHING THE PROJECTOR ON AND OFF

WARNING: Connect the projector to a power supply with a

nominal voltage within the following values: 110-240 V AC,

50/60 Hz. It must be earthed (Fig. 12).

Position I : on

Position O : off

Power switch

Fused power

socket

Power plug

Fig. 12

In position I the projector will initialise itself (red and green leds

on) and then goes into standby mode (red led on) (Fig. 13).

HDMI

AUDIO

OUT

ZOOM

CONTROL (RS 232)

GRAPHICS RGB

R/Cr

G/Y

B/Cb

ATTENTION: pour ne pas compromettre

la protection contre les resque d'incende

remplacer par un fusible de meme type

et de mems caracteristique

CAUTION: for continued protection against

risk of fire, replace

only with same type

and rating fuse.

SWITCH ON FROM STANDBY

With the remote control press one of the keys (Fig. 14):

- 0 to select the last imput selectet after last switching off.

- 1-9 to select the correspondent imput.

With the keypad: press the ON/OFF button.

ZOOM

CONTROL (RS 232)

GRAPHICS RGB

When the unit is switched on from standby the lamp switches

on; after a brief period of warming up, the image displays

(green led on).

If a very short time has passed since the unit was last switched

off, the lamp may not switch on beause it is too hot.

Just wait a few minutes for the lamp to cool down sufficiently.

Note:

At power ON the picture could be displayed with a wrong

orientation; this is not a fault.

Fig. 13

Fig. 14

Downloaded From projector-manual.com Sim2 Manuals

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 30 31

Comentarios a estos manuales

Sin comentarios

Sim2 HT 280E Manual de instalación Pagina 11

Comentarios a estos manuales

Relacionado con productos y manuales para Proyectores de datos Sim2 HT 280E