Sim2 C3X Lumis Manual de instalación descargar pdf (Pagina 4)

C3X Lumis

2 SAFETY WARNINGS

CAUTION

To reduce the risk of electrocution, disconnect the power

supply cable on the rear panel before removing the top

cover of the projector. For technical service refer to trained

personnel authorised by the manufacturer.

LAMP WARNING

If the lamp suddenly explodes with a loud bang, turn off the projector immediately and air the room thoroughly before using it.

Do not attempt to replace the bulb: contact your local service centre.

ENVIRONMENTAL INFORMATION

This product contains materials derived from natural resources during its manufacture. It may contain materials which constitute

a health and environmental hazard. To prevent harmful materials from being released into the environment and to promote the

use of natural materials, SIM2 Multimedia provides the following information regarding the disposal and recycling of the product.

Waste electrical and electronic materials (WEE) should never be disposed of in normal urban waste disposal facilities. The label on

the product, shown here, indicating a cancelled garbage can, is intended to remind you that the product requires special handling

at the end of its service life. Materials such as glass, plastic and some chemical compounds are recoverable and can be recycled

for reuse. Please observe the following instructions:

1. When you no longer wish to use your electrical and electronic equipment, take it to your local waste disposal facil-

ity for recycling.

2. You may return your old equipment to your dealer free of charge when you buy a new product which is equivalent

or has the same functions as the old one. Call SIM2 Multimedia to ﬁnd your local dealer.

3. If you need more information regarding recycling, reuse and product exchanges, please contact customer service

at the number given in the manual.

Lastly we suggest further measures to safeguard the environment, such as recycling of internal and external packaging (including

that used for shipping) in which the product was delivered. With your help, we can reduce the amount of environmental resources

required to make electric and electronic equipment, reduce the use of waste tips for used equipment and, in general, improve our

quality of life by making sure that hazardous materials are correctly scrapped. Incorrect treatment of the product at the end of its

service life and failure to follows the above disposal instructions are punishable under local legislation.

CAUTION

As the optical system of the C3X Lumis is extremely compact and has the purpose of developing very high brightness and con-

trast, it is possible that a small quantity of light is visible out of the projection area varies depending on the type of lens used and

the zoom and shift setup. This characteristic of the optical system is to be deemed as normal. In order to reduce this effect SIM2

recommends that the area surrounding the projection screen is as dark as possible.

The C3X Lumis is a three DLP ™ chip projector and uses three high resolution DMDs ™ (Red, Green, Blue). These three DMDs ™

are precisely aligned through a high precision process which reduces the alignment error to within the foreseen limits of tolerance.

The maximum limits of misalignment are the following: Screen Centre: up to 0.7 pixels between each colour. Screen Borders: up

to 2 pixels between each colour. Note: 1 pixel corresponds to 10 thousandths of a millimetre on the DMD™.

Read all chapters of this manual carefully before switching on the projector. This manual provides basic instruc-

tions for operating the C3X Lumis system. Installation, preliminary adjustments and procedures that necessitate

the removal of the top cover and contact with electrical components must be performed by authorised, trained

technicians. To ensure safe operation and long term reliability use only the power cables supplied by the manu-

facturer. Observe all warnings and precautions.

Read this manual carefully.

This manual contains important information on how to install

and use this equipment correctly. Before using the equipment,

read the safety prescriptions and instructions carefully. Keep

the manual for future consultation.

Do not touch internal parts of the units.

Inside the housing there are electrical parts carrying dangerously

high voltages and parts operating at high temperature. Never open

the housing. Entrust all servicing and repair work to an authorised

Service Centre. Opening the housing voids the warranty.

Disconnecting the appliance from the power supply.

The device which disconnects the unit from the mains is the

power plug. Ensure that the power cable plugs and the elec-

trical mains socket outlets are easily accessible during instal-

1 2 3 4 5 6 7 8 9 ... 30 31

Comentarios a estos manuales

Sin comentarios

Sim2 C3X Lumis Manual de instalación Pagina 4

Comentarios a estos manuales

Relacionado con productos y manuales para Proyectores de datos Sim2 C3X Lumis